Question Unable to get KAMP bed mesh to work with Klicky

[Ho-whizzle]

Hi all,

I am stuck. I have installed KAMP with no issues so far but when I start a print it will not go to attach the probe to start the bed mesh.

Please help

 

[Sohrab]

Hi all,

I am stuck. I have installed KAMP with no issues so far but when I start a print it will not go to attach the probe to start the bed mesh.

Please help

There is a video on youtube about native adaptive bed mesh showing process but at the end there is something you shoud do:
1- in stepper z adjust z end stop offset.
2- in probe, adjust z offset for probe.
be carefull, go from 0 to about 6.0 in 1mm steps and check adaptive bed mesh while printing.
I did it today and end with 5.6

 

[vukrook]

Assume your KAMP_Settings.cfg contains
variable_probe_dock_enable: True
as well as attach/dettach macro names...

Then I'd check and resolve those Unknown command messages @ 21:45 appearing in the console after an attempt of 'Attaching probe' was made @ 21:44.
Might be there's some weakness in the macros causing their processing to fail.