VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by walnutidle_V2.4807
-
W
Question Print at z axis is always ~0.2 mm too high
Found my mistake. I have overseen a setting for ours. m( This post can be deleted.- walnutidle_V2.4807
- Post #2
- Forum: Slice and Print
-
W
Question Print at z axis is always ~0.2 mm too high
Hi everyone, I'm trying to figure out why my printed calibration cube is always ~0.2mm higher in z axis than it should be when using OrcaSlicer. Printer is a Voron2.4. I use 0.2mm layer high at all layers. While the x and y axis are good, for example x=19.96mm and y=19.97mm, the Z axis is...- walnutidle_V2.4807
- Thread
- Replies: 2
- Forum: Slice and Print