Recent content by Washable

DOH!! I just went verify the specs in the kit. Don't know how I overlooked this. THANKS!!

Thank you for your reply.

I recently finished my 350x350 Trident and also set up Can bus, Voron tap, sensorless homing, and adaptive bed mesh. Everything checks out except for horrible z squishing. I printed an XYZ calibration cube which measured 22.7mm wide, 22.5mm deep, but only 12.5mm in height. I thought maybe...

I built my first 2.4 a few months ago and have printed 100s of successful prints before this problem started. It seems that the nozzle is dragging through the previous layer. I ended up getting a trident also and was having the same issue right out of the gate. I've tried different slicers...