Recent content by Wesley910

I’ll run through the drive system again. im running 42STH48-2504AH steppers do I need to change the run current from the .8 that’s in the config file?

Something is off somewhere cause I’m losing steps

You are the MAN! it was the speed

Here’s a video, I first home it then hit the z tilt button. You can see it move slightly and than start probing as if it’s at the top left

sorry now the printer log

ok, heres both

Where should be safe home z be with a tap? I set it to 150,150 to put it in the middle of the bed. it seems if I change this to 0,0 the z tilt work fine.

the gantry trys to run through the back of the machine, how and which logs do I post?

It’s almost like it thinks the safe home position of 150,150 is 0,0 and try’s to move to those points from there.

z_positions: -50, 18 150, 348 350, 18 points: 30, 5 150, 245 270, 5

I've had a problem with the z tilt command, this is a new build and I'm currently going through the initial start steps. If I home everything works and it goes to its z safe, I then run the z tilt and the machine acts like it doesn't know where it's at and it goes to the wrong points crashing...