Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Did that. I plugged the suspect motor into the X driver with it's respective cable and got the same results, so it doesn't appear to be a driver or wiring related fault.
But...
I changed this setting, and holy crap - it actually homed successfully. I don't know why, but this worked. Crisis...
Belts look like they're routed fine, but I attached pictures just in case.
My config is based off the official Voron one for the M8P, with the necessary changes for the EBB among others. Kinematics are set to "corexy".
I did end up sending STEPPER_BUZZ on the X and Y motors, and I found that...
Hi all,
I'm close to finishing my first Formbot 2.4R2 250mm build and have started testing things out before I pop the panels on. I'm running into a pretty nasty issue with XY motion while attempting to home. It will drop Z slightly, then when homing X, the printer moves in a rough diagonal to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.