Recent content by Ytrahcodo

Which problem are you asking about? In general, I was able to find various configuration examples scattered around the web and patched them together with some edits for my particular printer. Regarding "wiring of ldo board", this was a Formbot kit. It didn't have any boards from LDO.

Did you do z cal and QGL first? 5mm tilt is ridiculous - you would be able to see that by eye.

I just finished a 2.4 from a Formbot kit that supplied a Bigtree Tech HDMI 5 touch screen. It's a nice screen but I find that it gets in the way when moving the Voron around on the bench. It's too big to fit flush with the bottom skirting, so it juts out at an angle on a custom printed bracket...

First print with Polymaker ASA. Coming out very nice so far after 8 hours. About 6 hours left.

The 15.6mm figure in the manual is given as a starting point. From there you are expected to make further adjustments visually when assembling. The problem with this dimension is that the thickness of the gear is not the same on all parts. In the CAD file for the CW2 the gear is 4mm thick...

It's been several days now of software installation, config files tweaking, and basic tuning. But it's running now, YAY! After a couple failed attempts to get something to stick to the PEI build surface, it printed it's first Benchy, which came out nice considering I haven't done any input...

Day 5 , 6 - 1/18, 1/20: electrical installation and wiring. Instead of a Raspberry PI, the Formbot kit comes with a Bigtreetech "BTT PI". I would have rather they left this out and saved me the the money since I already have a spare Raspberry PI 3, but I guess it's only about $30 anyway. The...

Day 3 - 1/14: Assembled the Clockwork 2 extruder and Stealthburner. This was a bit more complicated since the Formbot version of the SB has some differences due to their custom toolhead PCB and parts choices. The gears they provided for the CW2 didn't mesh properly at first. The stepper pinion...

Day 2 - 1/11: Got the Z motors, idlers, and Z rails installed. Had to print the rail alignment tools first on my old CR10 before tightening the rails. So far everything was straight-forward, by the book.

Had the frame assembled and squared up on day 1. I had some huge 24" x 24" thick rectified porcelain tiles on hand that are very flat, so one of these served as my frame build surface during the squaring stage.

Just finishing up my first Voron build. Ordered the Formbot 2.4 R2 "Pro" 350 Kit direct from the Formbot site on 1/05 (US delivery) and received everything on 1/10. Started unpacking on 1/11. The Formbot PRO Kit includes a lot of the current common upgrades such as TAP, Nevermore, toolhead PCBs...