Recent content by zig

It is a highly modified Voron 2.4 R2. I’m just finishing it. Pros: 1. Mounts low voltage electronics on top and high voltage underneath. This was the biggest appeal for me. 2. Looks very cool and professional. Multiple skirt options for top and bottom. Curved corners. Thicker structure with...

Yeah, I expected it was some kind of wiring problem, but it must have been the board. I'm a bit disenchanted with FYSETC. This 2.3 Spider was replacing the 2.2 Spider that failed. And all I got from support was "I'll ask the engineers", then silence. 0 for 3 on that one. I replaced it with a...

I worked on the overheating issue for days. Disconnected all wires except power. Still overheating. No help at all from customer support. Finally threw it in the trash and bought an Octopus. Everything works fine now.

I use adaptive meshing (see https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging), which creates a set of probe points sized for the given print job. It takes a little work to set up, so I would get the regular meshing to work before diving into this. I use textured PEI most of the...

I’ve built tap a couple times too. Let me know if I can help.

Another tip: Make sure your filament roll spins easily and that the filament is not kinked or tangled.

Did you figure this out? I converted both my printers to CAN recently so I might be able to help.

This is interesting. I just upgraded from a 2.2 to a 2.3 board after my 2.2 failed following a year of working fine. Same config, wiring, etc. double checked all the connections. Rebuilt and reinstalled firmware. Mine didn’t fry, but it is running super hot, up to 120C before I could turn it...

A few months ago, I bought an LGX lite to use with the 0.1 build was starting. There was a nice (unofficial, but widely used) tool head mod that allows this. Then one morning 0.2 was released! Hooray! Oh but my LGX mod no longer works. Grumble. Has some enterprising person designed a way to get...