2.4 rev D, sensorless and beacon contact

[StreetSports]

Here we go. I have it set to, when there is no mesh or z offset saved already, first it taps the nozzle to the bed a few times via beacon contact, moves the sensor over the area that was tapped by the nozzle, moves the nozzle to the correct offset, measure with the beacon non contact sensor, saves the correct z offset for the nozzle so that all scans will now be touchless, measures the corners, does quad gantry leveling, checks its work and then goes into the 15x15 bed scan twice(turned it down from 25x25. Oh and first it does sensorless homing.

 

[zerosnugget]

Looks awesome! Do you mind posting your Klipper config somewhere? I'm trying to get sensorless homing to work with beacon contact too and I feel like hitting a brick wall. Primarily the homing override doesn't really seem to work but I would be interested in the [beacon] and [bed_mesh] config too! Did you have issues in the past regarding bed mesh?

 

[5twenty]

Looks awesome! Do you mind posting your Klipper config somewhere? I'm trying to get sensorless homing to work with beacon contact too and I feel like hitting a brick wall. Primarily the homing override doesn't really seem to work but I would be interested in the [beacon] and [bed_mesh] config too! Did you have issues in the past regarding bed mesh?

I had to mess with the sensitivity settings on mine, took a good while, but once it was done, it's done. So far. I'd still like to fine tune it a bit more, but it works.