I've finally assembled/configured my first voron (a 2.4 kit I bought three years ago). I appreciate that it uses common, off-the-shelf components (and printable parts), the great documentation, and the public/open-source designs. This is how things ought to be done - entirely opposite from the planned obsolencece of most consumer electronics/appliances.
Most often I print with ASA, sometimes nylon, and I need a filament dryer. It must accomodate a spool sizes up to 3KG (e.g. Inner Hole Diameter: 55±1mm, Spool Diameter: 250±1mm, Spool Width: 117.2±2mm). Secondly, can voron owners request serial numbers on the forum instead of reddit? Thanks.
Most often I print with ASA, sometimes nylon, and I need a filament dryer. It must accomodate a spool sizes up to 3KG (e.g. Inner Hole Diameter: 55±1mm, Spool Diameter: 250±1mm, Spool Width: 117.2±2mm). Secondly, can voron owners request serial numbers on the forum instead of reddit? Thanks.
Last edited:
