- Printer Model
- 2.4r2
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
Hello everyone,
My stock z-endtop will not produce consistent readings...or at least I can say, when I have it enabled as a z-endstop my z-offset is +/-.5. I've rebuilt it twice and tried sexbolt mod with no help. I converted my Voron back and forth between using the klicky as a z-probe and not. My latest attempt to fix/utilize the z-endstop failed again...I'm trying to revert back and it now refuses to use klicky as a z-probe. It simply uses the stock one. I followed this guide :
docs.vorondesign.com
Attached are my configs. I would appreciate any help.
My stock z-endtop will not produce consistent readings...or at least I can say, when I have it enabled as a z-endstop my z-offset is +/-.5. I've rebuilt it twice and tried sexbolt mod with no help. I converted my Voron back and forth between using the klicky as a z-probe and not. My latest attempt to fix/utilize the z-endstop failed again...I'm trying to revert back and it now refuses to use klicky as a z-probe. It simply uses the stock one. I followed this guide :
Klicky Probe as Endstop with constant Z-Offset
Voron Official and Community Documentation
Attached are my configs. I would appreciate any help.