turlututumaske
New member
- Printer Model
- Switchwire / Enderwire
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
Hi evryone
I just finished installing my enderewire but a strange thing happens
when I do a zoffset the machine responds correctly, I save the parameters but as soon as I do a test again everything comes back to the basics (and the zoffset is too far of the bed) I tried with klipperscreen and the console( with Z_OFFSET_APPLY_PROBE
SAVE_CONFIG )but the problem persists I’ve been on this for several days and I don’t see the solution, I’m depressed
I have a cartographer probe work well before with my stealthburner on my ender 3v2
I just finished installing my enderewire but a strange thing happens
when I do a zoffset the machine responds correctly, I save the parameters but as soon as I do a test again everything comes back to the basics (and the zoffset is too far of the bed) I tried with klipperscreen and the console( with Z_OFFSET_APPLY_PROBE
SAVE_CONFIG )but the problem persists I’ve been on this for several days and I don’t see the solution, I’m depressed
I have a cartographer probe work well before with my stealthburner on my ender 3v2
