Question Newly built Switchwire randomly stopping and becoming unresponsive.

[Rusty105]

I finished building my Switchwire a few weeks ago and have been dialing it in, tuning, cleaning up wiring etc and printing with it. I have done a few 4+ hour prints with mostly no issues, some calibration stuff, but mostly worked out. The problem I am having now is that the printer randomly stops mid print and the web interface (Mainsail) becomes completely unresponsive. I need to turn the printer off and back on to recover.

Hardware:
Manta M5P+CB1 V2.2 Core board 1GB DDR3
LOD Nitehawk-SB tool head board
Logitech C270 Webcam

Other symptoms:
Webcam occasionally blanks out and wont recover unless I power down and restart.


Any idea where to look for the issue?


Thanks!!

On Edit.... Just adding... When it becomes unresponsive I do not see any errors on the web interface, it just looks 'frozen'

 

[NoGuru]

I would recommend a PI4, its just a bit better over all.

 

[Rusty105]

The Manta M5P uses a compute module, I could look to see if a current RasPi compute would work....

 

[NoGuru]

The Manta M5P uses a compute module, I could look to see if a current RasPi compute would work....

Yes, I meant the CM4. It can use it.