Pause by Tap trigger while printing...

[Gravel3170]

Is there a way to pause the print if the print head hits a part hard enough to trig the tap switch?
Thanks.

 

[120decibell]

It would depend on Klipper watching the switch for input, which normally isn't happening during a print.

 

[bojan]

I was wondering too can it be used as an emergency stop.

 

[claudermilk]

I was hoping it would be able to do that. Kind of like a filament sensor.

 

[Gravel3170]

It would depend on Klipper watching the switch for input, which normally isn't happening during a print.

Good idea for the Klippers team...