So Yesterday I did updates...and boom...printerstopped working. after up and down for a day, this morning I decided to reload all firmware, MANTA, EBB and EDDY. all over canbus. low and behold she worked again.
Started a print, finished.
started second print, finished.
Started 3rd print, finished.
However...after finishing the 3rd print, klipper wont connect anymore. I've no idea WTF went wrong between that print finishing and me looking at the printer.
i've attached the moonraker.log. Cannot get the klippy.log for some reason. ALSO, in WinSCP klippy.log is way larger than moonraker.log. not sure if this is normal
ANY help would be really appreciated
Started a print, finished.
started second print, finished.
Started 3rd print, finished.
However...after finishing the 3rd print, klipper wont connect anymore. I've no idea WTF went wrong between that print finishing and me looking at the printer.
i've attached the moonraker.log. Cannot get the klippy.log for some reason. ALSO, in WinSCP klippy.log is way larger than moonraker.log. not sure if this is normal
ANY help would be really appreciated
