- Printer Model
- Fysetc Voron 2.4 kit
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
This whole thing is weird: Powered on the V2.4 and it gave me an error about something missing in the MCU section. I deleted my backup printer.cfg files and then when I went to edit printer.cfg, it was empty. I had a year old printer.cfg that i tried using and ran into all sorts of problems.
When I start either a new or old print, the nozzle and bed heaters go to zero, all axes home, and the bed heater never get reset but the nozzle is heated to a fixed 255. The old printer.cfg does not have any bed meshing either. I've attached my printer.cfg any suggestions or sample configs would be appreciated.
BTW, I am running a v2.4 with Tap, can bus on a Fysetc Spider 2.2.
When I start either a new or old print, the nozzle and bed heaters go to zero, all axes home, and the bed heater never get reset but the nozzle is heated to a fixed 255. The old printer.cfg does not have any bed meshing either. I've attached my printer.cfg any suggestions or sample configs would be appreciated.
BTW, I am running a v2.4 with Tap, can bus on a Fysetc Spider 2.2.
