SB2209 CAN V1.0(RP2040) wiring wont fit onder cover.

[KnotI]

I am have problems getting the SB2209 CAN V1.0(RP2040) wiring to fit onder the cover of the stealthburner. I did print the cover for the SB2209 but it is still pressing against wiring.
Am I doing somenthing wrong? Is there yet another cover I can print or should I remove it altogether (would prefer not to remove)
I am buulding the revo version of the stealthburner FYI
Please help I am so close do done on this build

 

[dthomsons]

Did you find a solution for this? I'm having the same issue. Printed a few different covers now, all seem to have the same issue.