What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

OneTwo3D - All you need for Your Voron

Setting up my SB2240canbus with Rapido hotend thermistor

@Jusmu Is your temperature reporting correctliy?
I connected my resistor (104nt-4-r025h42g) to TH0. But it reports a tempreture arround 30°C. But roomtemp is arround 20°C. I tried everything, nothing helps.
Code: 
sensor_type: PT1000
sensor_pin: EBBCan:gpio27
When i change the sensor_type to 104nt-4-r025h42g, the shown temp is arround 160°C...

Thanks
 
figugegu said:
@Jusmu Is your temperature reporting correctliy?
I connected my resistor (104nt-4-r025h42g) to TH0. But it reports a tempreture arround 30°C. But roomtemp is arround 20°C. I tried everything, nothing helps.
Code: 
sensor_type: PT1000
sensor_pin: EBBCan:gpio27
When i change the sensor_type to 104nt-4-r025h42g, the shown temp is arround 160°C...

Thanks
Click to expand...
Do you have the 2.2k jumper installed? (You shouldn't. But if you do, it would explain the erroneous readings)
 
I believe the temperature readings were within 2 degrees C compared to my room temperature. Now my voron uses LDO Nitehawk USB toolboard. There i have similar problem: temperature says 30 and room temp is around 24°C. But that is another topic to tune and for me ask.
 
You must log in or register to reply here.

Similar threads

8
BigTreeTech SB2209 CAN Bus Expansion Board with Rapido 2 hf hotend not compatible?
Replies
4
Views
3K
İsoBaba
İ
snow 3dp
EBB sb 2209 thermistor issues
Replies
19
Views
1K
Karl_Barx
K
A
Voron 2.4 Clockwork 2 + E3D Revo extrusion problem
Replies
4
Views
3K
majic79
M
Top