Slicers issues (SuperSlicer)?

[MichaelOToole]

Been using Superslicer since the beginning but a recent print at the exact same layer it becomes whispy, as if it suddenly changed to extruding at 60 or 70%.
Seven or eight attempts in a row (changed filaments, just in case) have this issue, printing other items are fine, it's just this one print that has issues... I have to assume a slicer issue.

Best to test the print sliced with another slicer, to determine if it's slicer related, perhaps Cura? any suggestions?
Ideally a slicer with the Voron settings...

Mike

SuperSlicer Version: 2.5.59.13

 

[lord-carlos]

OrcaSlicer and Prusa Slicer have voron profiles. But everyone has a different way to handle [print_start] so you have to adjust them to your needs in any way.

You can also export the g-code in super slicer, then import the g-code in any of these two slicers and maybe look at extrusion width or similar.

 

[MichaelOToole]

Good idea, I did this in the past but forgot... that's what happens when you haven't used your printer in a very long time... grey cells are asleep...
Will try both

Installed both but as Orca setup for my Voron was easier, I went with it.
I sliced the problem print and it printed perfectly.
I had previously loaded the gcode file produced my SuperSlicer in to Cura and it reported errors...

Prusia slicer didn't behave as expected and I'm too lazy to search for fixes ATM...

Interestingly enough I tend to avoid PETG as I had varying results in the past but the test print above with Orca and PETG was flawless... solving two problems with one change.
Thanks for the help...
Mike