Hi,
a while ago I started my Voron 2.4 build.
While going, I decided that I like the idea of having a CAN connected board on the toolhead to minimize cabling.
As I did not like the available ones completely, I decided to create a specific one.
So I ended up with the following open source project:
github.com
It already works quite well and my printer is one step closer to 'finalization' (I'm fully aware that it will never be finished...)
I just like to know if this is also interesting for anyone out there except me...
I am not in a position to sell this, but if there is enough interest we could try to get a batch built.
If somebody would have ideas how to mechanically integrate such a board more nicely into the overall toolhead design, I could also make a redesign of the board to match that.
br
Richy
a while ago I started my Voron 2.4 build.
While going, I decided that I like the idea of having a CAN connected board on the toolhead to minimize cabling.
As I did not like the available ones completely, I decided to create a specific one.
So I ended up with the following open source project:
GitHub - Richy42/votoco
Contribute to Richy42/votoco development by creating an account on GitHub.
github.com
It already works quite well and my printer is one step closer to 'finalization' (I'm fully aware that it will never be finished...)
I just like to know if this is also interesting for anyone out there except me...
I am not in a position to sell this, but if there is enough interest we could try to get a batch built.
If somebody would have ideas how to mechanically integrate such a board more nicely into the overall toolhead design, I could also make a redesign of the board to match that.
br
Richy