benster310
New member
Does anyone have this combination on a Voron 2.4 Rev D?
I am bussy building a Voron 2.4 Rev D 350mm printer, and ordered the phaetus Rapido UHF hotend, as well as a Knomi 2. I found STLS for the slightly longer Stealth Burner, but it looks like the X-Carriage might be a bit too short to accomodate the Eddy probe. Has someone by any chance customized the x-carriage to have the middle secction where the Klicky Probe or Eddy attaches, are a bit lower to accomodate for the longer Rapido UHF hotend?
I am bussy building a Voron 2.4 Rev D 350mm printer, and ordered the phaetus Rapido UHF hotend, as well as a Knomi 2. I found STLS for the slightly longer Stealth Burner, but it looks like the X-Carriage might be a bit too short to accomodate the Eddy probe. Has someone by any chance customized the x-carriage to have the middle secction where the Klicky Probe or Eddy attaches, are a bit lower to accomodate for the longer Rapido UHF hotend?
