Stealthburner EBB 2209 RP2040 Kinky probe wiring

[jateu01]

Printer Model

Voron 2.4r2

Extruder Type

Clockwork 1

Cooling Type

Stealthburner

Just purchased the can board for stealth burner. I am happy with my klicky probe set up but I cannot find any instructions on where to wire the existing klicky wire to the can board.

Probably a silly question but appreciate and help and advice.

 

[NoGuru]

I think you can just wire to where any end stop is. So you have an open or closed loop.

 

[jateu01]

I think you can just wire to where any end stop is. So you have an open or closed loop.

Can I use the gnd and pin at the bl touch problem connector and just allocate pin in config?

 

[NoGuru]

Can I use the gnd and pin at the bl touch problem connector and just allocate pin in config?

Yes, that should be fine.