Stealthburner with Rapido UHF

[Jusmu]

I have Phaetus Rapido UHF for my Stealthburner. It seems to have a mechanical problem/challenge. The UHF hotend is little bit longer compared to other version of Rapido. is there a STL adapter to get the Ompron height probe lower or do I just change the nozzle to shorter and good to go? I have found STLs for the UHF stealthburner but this height sensor is the question.

 

[NoGuru]

Printables

www.printables.com

I was using the same setup with a Beacon probe so I know it is possible .

 

[Jusmu]

Ok, thanks. I'll continue my tests with the shorter nozzle.