- Printer Model
- Voron 2.4
- Extruder Type
- Other
- Cooling Type
- Stealthburner
I have recently been receiving some errors regarding my steppers and/or motors, see below:
"TMC 'stepper_z2' reports error: GSTAT: 00000001 reset=1(Reset)"
A few weeks ago I received this error for one of my A/B motors, and this always occurred at the same Z-height, so I figured one of the wires in the cable chains was broken. So I replaced the wiring harnesses for both A/B motors, and I thought I fixed the issue.
Now I am getting the error message above, but the number of the Z-Motor is changing every time. I doubt it is a wiring issue as the wiring is not moving, or in a cable chain. I don't believe it is the motors (Moons motors from the Formbot kit), as the number in the error changes. The only thing I can think of, is my steppers are dying (TMC 2209) or my Octopus Board is dying.
Any thoughts, or anyone else experience something similar?
"TMC 'stepper_z2' reports error: GSTAT: 00000001 reset=1(Reset)"
A few weeks ago I received this error for one of my A/B motors, and this always occurred at the same Z-height, so I figured one of the wires in the cable chains was broken. So I replaced the wiring harnesses for both A/B motors, and I thought I fixed the issue.
Now I am getting the error message above, but the number of the Z-Motor is changing every time. I doubt it is a wiring issue as the wiring is not moving, or in a cable chain. I don't believe it is the motors (Moons motors from the Formbot kit), as the number in the error changes. The only thing I can think of, is my steppers are dying (TMC 2209) or my Octopus Board is dying.
Any thoughts, or anyone else experience something similar?