My setup is a self build Voron 2.4 with SB2240 via CAN
after fixing some issue stepper motor wiring and some other minor issues everything works fine now except one thing.
i am not able to extrude :/
so after rewiring the stepper motor the right way the TMC2240 driver stopped sending error messages when i want to extrude, but now i have everytime the same behaviore.
i heat up to 180°C
i press the "extrude" button with speed 1 length 10 .....
console log states
16:40
M83
G1 E-10 F60
..... but nothing happens.
i press the button a second time ... and this happens
16:40
Klipper state: Disconnect
16:40
FIRMWARE_RESTART
16:40
M83
G1 E-10 F60
any ideas? no errors nothing else is shown :/ klipperlog is more or less "empty"
after fixing some issue stepper motor wiring and some other minor issues everything works fine now except one thing.
i am not able to extrude :/
so after rewiring the stepper motor the right way the TMC2240 driver stopped sending error messages when i want to extrude, but now i have everytime the same behaviore.
i heat up to 180°C
i press the "extrude" button with speed 1 length 10 .....
console log states
16:40
M83
G1 E-10 F60
..... but nothing happens.
i press the button a second time ... and this happens
16:40
Klipper state: Disconnect
16:40
FIRMWARE_RESTART
16:40
M83
G1 E-10 F60
any ideas? no errors nothing else is shown :/ klipperlog is more or less "empty"
