hiveworldjunkie
New member
Hi all, little bit stumped.
Trying to get katapult to run on the BTT EBB 2240 STM32G0B1 but keep butting my head against locating the UUID of the Toolhead board after installing katapult via. DFU (120Ohm R installed on EBB board and U2C) State LED is flashing constantly? Reset tried several times and a full reinstall of katapult carried out on the Toolhead.
Setup - RPI 4 / Octopus 1.1 / BTT U2C
Using CANBUS Esoterical guide all of the U2C / RPI4 / Mainboard flashing was all pretty much straight forward and katapult is on the system, just not recognising the tool head. Note: Toolhead when connected via. USB in DFU is recognised.
Update: Still no further. Unplugged the toolhead and I am still seeing the original CAN UUID with klipper which I think it the RPI. The only thing I haven't done that was suggested is set printer.cfg file with CAN settings but not sure that should matter to detect CAN nodes from RPI to U2C to EBB ?
The RPI CAN is operational and active with the bitrate set to 1000000 (everything has been flash to this speed)
Tool head is still flashing away and no amount of double click reset alters anything.
Any help would be much appreciated, Thanks in advance.
Trying to get katapult to run on the BTT EBB 2240 STM32G0B1 but keep butting my head against locating the UUID of the Toolhead board after installing katapult via. DFU (120Ohm R installed on EBB board and U2C) State LED is flashing constantly? Reset tried several times and a full reinstall of katapult carried out on the Toolhead.
Setup - RPI 4 / Octopus 1.1 / BTT U2C
Using CANBUS Esoterical guide all of the U2C / RPI4 / Mainboard flashing was all pretty much straight forward and katapult is on the system, just not recognising the tool head. Note: Toolhead when connected via. USB in DFU is recognised.
Update: Still no further. Unplugged the toolhead and I am still seeing the original CAN UUID with klipper which I think it the RPI. The only thing I haven't done that was suggested is set printer.cfg file with CAN settings but not sure that should matter to detect CAN nodes from RPI to U2C to EBB ?
The RPI CAN is operational and active with the bitrate set to 1000000 (everything has been flash to this speed)
Tool head is still flashing away and no amount of double click reset alters anything.
Any help would be much appreciated, Thanks in advance.
