Ho-whizzle
Well-known member
hello,
I am not stranger to Voron nor Klipper but this is the first time I am building Formbot Micron+ which is based on a V2.4 (I have built a trdient) and is using the BTT Manta M8P with CB1 board which is giving a lot of headaches as my weakness is software and coding.
I have spent days building the menuconfig and trying to flash it to the baord but it will always fail, Ihave tried many method with the same outcome, I have used Kiauh in past and it been good to me until now and I am stuck. I have attached a screenshot of the error and it always says "failed to flash to 0483:df11 which the M8P in DFU mode and error running dfu-util.
Hope you can help.
many thanks in advance
I am not stranger to Voron nor Klipper but this is the first time I am building Formbot Micron+ which is based on a V2.4 (I have built a trdient) and is using the BTT Manta M8P with CB1 board which is giving a lot of headaches as my weakness is software and coding.
I have spent days building the menuconfig and trying to flash it to the baord but it will always fail, Ihave tried many method with the same outcome, I have used Kiauh in past and it been good to me until now and I am stuck. I have attached a screenshot of the error and it always says "failed to flash to 0483:df11 which the M8P in DFU mode and error running dfu-util.
Hope you can help.
many thanks in advance
