Dutchronnie
Well-known member
Thanks for your help, 3dCase it definitely made a difference. The print quality is now better at higher speeds. The Voron’s speed is now on par with the Bambu Lab X1C.
This improvement came after I copied the speed settings from the Bambu Lab into orcaslicer for the Voron.
It’s now clear to me that the max speed settings in printer.cfg don’t actually control the print speed—that’s determined by the slicer.
Glad I finally figured that out!
This improvement came after I copied the speed settings from the Bambu Lab into orcaslicer for the Voron.
It’s now clear to me that the max speed settings in printer.cfg don’t actually control the print speed—that’s determined by the slicer.
Glad I finally figured that out!