V0 bed levelling

[essence_thon4]

Printer Model

V0.2

I am planning to build a Voron, but I don't know if I should build a V0 or another printer. My question how does the V0 level itself, is there an end stop on the Z-axis and we set manually the screws ? Can someone explain me

 

[bomtarnes]

There is a switch at the bottom of the Z axis, and 3 bed screws for manual levelling. The bed is small enough that an electronic sensor is not really required (although some choose to add one).

 

[lord-carlos]

I build the v0.0 and oh my god it was a pain the the behind. Though I think they fixed a lot with 0.1 and 0.2.
Definitely get a kit that does not have the original extrusion bed. But one with for example Kirigami Bed. Saves time and pain.

Voron Trident might be easier to build.