V0 bed levelling

[essence_thon4]

Printer Model

V0.2

I am planning to build a Voron, but I don't know if I should build a V0 or another printer. My question how does the V0 level itself, is there an end stop on the Z-axis and we set manually the screws ? Can someone explain me

 

[bomtarnes]

There is a switch at the bottom of the Z axis, and 3 bed screws for manual levelling. The bed is small enough that an electronic sensor is not really required (although some choose to add one).

 

[lord-carlos]

I build the v0.0 and oh my god it was a pain the the behind. Though I think they fixed a lot with 0.1 and 0.2.
Definitely get a kit that does not have the original extrusion bed. But one with for example Kirigami Bed. Saves time and pain.

Voron Trident might be easier to build.

 

[claudermilk]

Trident would be an easier overall build. I started there and built a V0.2 later. Getting the bed leveled on the V0.2 was a pain, but once set you shouldn't need to touch it again.

 

[5twenty]

Just make sure you tram your bed with as much pressure as possible on the springs so they don't back out easily. I've had to go back to my first zero and readjust as I had the bed "loose" and it would get out of whack.

But once you have the bed dialed in, you don't have to touch it much after that, just dial in your Extrusion multiplier for each filament after.