Voron 2.4 homing issue

[Trimixdiver1]

This 2.4 was bought already assembled. Im new to 2.4, so I grabbed a generic cfg file that uses a octopus 1.1 board. I used the sensorless homing guide as it was set up this way before. I have the first two diag pins jumpered. When I issues a Y or X home command the head will move a bit but the Z gantry moves down in the front left corner. Any ideas?

I can include the cfg file if you tell me how

Thanks

 

[claudermilk]

Just click the Attach files button below the reply text box. Also, you might want to repost over in the V2 Forum for more specific support for your printer.

 

[shiftingtech]

Are you aware of the startup guide ? Following it tends to address a lot of these kinds of issues.