Recent content by Beaker

After more testing and acquiring a second fan to test if the RPM signal on the first wasn't working, I believe that the issue is with the input on my maninboard, Not sure if I did something wrong while wiring and shorted it out or what.... Anyway as of this point I decided to go another route...

EBB Flashing ***IMPORTANT: I have seen in several places that there is potential for some versions of the EBB to turn on the heater output while in DFU mode. Best to disconnect the heater until you are all done*** 1) Switch directories to Katapult and enter the make menu cd ~/katapult/ make...

The current documentation regarding getting these two parts working together from BTT is incomplete and user made info is scattered. I'm going to take a crack at fixing (some) of that. I would recommend doing all of this configuration before installing it into your printer if you can, it will...

Fiddling with the printer tonight, I was able to fix my issue with the Auto Z Calibration. It seems that one of the updates either uninstalled or broke the reference to z_calibration.py The fix was to SSH into the printer and run ./klipper_z_calibration/install.sh to reinstall the package. I...

Hello Everyone! I'm early into my Voron journey and I have it hit a couple of challenges that I could use some help with. For reference: #1 - Hotend fan RPM Monitoring I was following the Ellis Print Tuning Guide and decided that the RPM monitoring for the hotend fan was a great idea so I...