Recent content by billgeek

Thanks for all the great responses! To address some of them individually: I've seen VFA's mentioned on the K1 across the web and suspected the same, though I see no VFA's on rectangular objects only cylindrical. The consensus online to beat VFA's on these machines appear to be increasing...

I'm not certain if this is hardware, firmware or slicer related, but I've been running my Trident for about six months now. I thought the print quality is pretty decent, but I've since purchased a Bambu Lab P1S and this made me realize what "round" actually means. Circular objects on the...

As others have said, I believe this is likely due to tolerances and not having your machine perfectly dialed in. The first time I printed this was with the Ender 3 which I dialed in absolutely perfectly and they snapped together with zero issues. The second time was with the Stealthburner on my...

This was happening for quite some time, but somehow - I wish I knew how - this just stopped and now the nozzle LED's are always lit. At first I thought it was the label / sticker behind the part fan shorting out pins on the "daughter board", but after removing the label and replacing it with...

Everything on my new Trident seems to be working, aside from this small issue: I'm using the BTT SB2209 CAN board and while everything seems to be working as expected, as soon as the part cooling fan is set to above zero the nozzle LED's of the Stealthburner would switch off. When I try to...

Busy week at the office, so I've only had an hour here and there to work on the build. Still, I think I'm just about there! I have a few skirts left to print (left and right) and the latches for the bottom electronics cover. Once done, I can tidy up the electronics compartment a little before...

I jumped back into it today after going away this weekend, and so far things are coming along smoothly. Completed the CW2 and Stealthburner assembly Belt routing was fun... but done! Managed to get all of the electronics wired up and as tidy as I'm comfortable with I had a bit of an issue...

I've just started with a Trident 300mm build using PolyLite ABS Black for primary and eSUN ABS+ Peek Green accents. Frame is a Black LDO kit, hotend would be the Phaetus Dragonfly hotend (anything is better than the generic knock-off V6's) and finally an Octopus 1.1 board. "Mods" I'm going to...