What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by calmfornow

  1. C

    Figured out. Shutdown when try to home Octopus Max EZ

    Upadte 2 - Figured it out. I forgot to put the jumpers in place for the drivers to get voltage. UPDATE!! It is not only the Stepper_Z I just buzzed my X and Y and same shutdown, and same error, but related to the corresponding stepper selected to buzz. I just changed out my mainboard to the...
  2. C

    Not heating up after level with tap

    Nevermind. That worked!!!! I was dumb on the first attempt. Thank you!
  3. C

    Not heating up after level with tap

    No luck yet. I just reset my logs. Sending it again and will post log.
  4. C

    Not heating up after level with tap

    Yeah, that is what I found. I am going to check out what you sent as well. Thank you.
  5. C

    Not heating up after level with tap

    It says my log is too large. Any way to send it over or anything in particular from the log that would be helpful for me to edit it down? Okay. So, I searched everywhere to no avail for my issue. I have a fresh build (Voron 2 350mm) Specs are as follows Manta M8P BTT CB1 Chaos Labs CNC...
See more
Top