Recent content by covertaero

I am having the same problem with CURA gcode. Could someone point me towards a good tutorial or video on how to get a proper minimal START_PRINT and end print working with CURA. Seems a lot of talk about sort of a live interaction between a computer running both CURA and MainsalOS. I don't...

You were correct. The wrong pin designations were called out in Printer.cfg . There were two sets based on which rev Spider and the wrong set were commented out. Seems all is starting to come up working properly now and a restart returns a working machine. Now I have to verify all the pins...

Update, I messed with some pins and connected the hot end thermistor to the spider v2.2 directly and got past the ADC out of range error. Also had to put in an include statement for MainsailOS which worked and the dashboard came up. Hotend thermistor reads room temp pretty accurately but the bed...

Sorry forgot to paste this:

Trying to get past this ADC error. All research says extruder thermistor. Wondering if there is a better way to test. I have pulled the thermistor from the hot end and am trying to plug it into the Spider port directly. Can't find clear config info for this thermistor. It is the one that came...

The bootloader got me the below so success flashing I guess. Carrying on...

Thanks, I found those UART instructions and nothing worked for me. Probably me not the instructions.

Will do. Thanks.

Thought possibly that I hadn't done the final make command that creates klipper.bin file but this time ran through again just to make sure Still same results. Below are results again ls /dev/serial/by-id returned nothing... lsusb not in dfu mode: Menuconfig:

I'll collect a few more screen grabs tomorrow and try to work it out. I believe Lsusb was showing the DFU machine as that is where I got its address. I tried to make the make menuconfig look exactly like the instructions. Thank you so much.

Hello Again, I started the software install over using docs.vorondesign.com as suggested with a fresh USB cable and the UART cable for power. This did better but seems to be halted at the last verification step flashing the Spider. Here's a screen grab of the instructions I am following...

OK, thanks a bunch. I did follow the Voron manual to the letter until I got to the print head board and the Spider V2.2 differences. That's where I got in trouble. Easy to just reload. Thanks.

I installed Mainsail and klipper. Also had to find a config.txt through I think a Voron build instructions link. The Github was Fysetc... https://github.com/FYSETC/FYSETC-Voron-2 On face of wiring diagram there are some UART config instructions. No luck with them. Did a bunch of general...

Hello all, be gentle :) First Voron build 2.4 r2 mostly 350mm. I have an old CR10 (for years) and a TRONXY S5A. Decided to jump into a Voron 2.4 for all the right reasons. I have been toiling to get the build ready to flash and test. Kit was Fysetc I have bits of a few kits and a few other...