VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by CyberBorder

  1. C

    CANBUS problem MCU 'mcu' shutdown: Timer too close MKS Skipr and MKS THR 36

    Hello, I am having problems with my Voron 2.4 printer. I detail the main components: Board MKS Skipr CANBUS THR 36 The MKS skipr is connected by canbus to the thr 36 and by usb to the host mcu I use orcaslicer slicer Prints longer than two hours return two types of errors: MCU 'mcu' shutdown...
  2. C

    MCU error 'MKS_THR' shutdown: Timer too close only printing with ABS long prints

    The canbus configuration is the one recommended by the MKS thr36 github. It is 250000.
  3. C

    MCU error 'MKS_THR' shutdown: Timer too close only printing with ABS long prints

    I built my Voron 2.4 and after some problems it is now working correctly. Now I started printing with ABS and it was working fine but if I print for more than 3 hours I receive the following error. MCU 'MKS_THR' shutdown: Timer too close I tried printing the same files in PLA and no problems. I...
  4. C

    Strange step loss problem

    These are all the things I already tried: Adjustment of all straps Gantry belts Calibrate with Probe_calibrate Motor current The engines do not overheat Gantry Alignment Update Klipper Try another slicer Align belts well and have the same tension The test_print works perfectly change...
  5. C

    Strange step loss problem

    For a month now I have been having problems with my Voron 2.4, it loses steps when it prints. Now if I perform a TEST_SPEED at a higher speed and acceleration the printer does not lose steps. I thought it would be a problem with the printer colliding with the print due to a height problem and I...
  6. C

    Question problem with tmc2009 driver uart mode motor knock

    I am building a Voron 2.4, I have a MKS skipr board with TMC3009 V3.0 drivers connected via UART. As seen in the video below, the motors make a noise like a slight knock once per rotation. I already tried setting the stealthChop mode and it does the same thing, I even tried changing the...
  7. C

    Z axis movement problem

    Hello, I am building my first voron 2.4 I'm having a problem with the z axis: I do the home xyz, in x and y it works perfectly now in z when I tell it to go up 10mm it goes up 20mm when I tell it to go up 50mm it goes up 105mm and if I tell it to go up 75mm it goes up almost 200mm There are 4...
  8. C

    Mounting problem with xy system

    I was looking at what they told me. relubricate the linear guides, I passed the belts again and checked to see if they were stuck anywhere, the movement improved a little but it is still not fluid (it is my first Corexy printer, my other printers are cartesian and these the movement of the axes...
  9. C

    Mounting problem with xy system

    Hello, I am assembling a 350mm Voron 2.4 and when it comes to assembling the x system belts, I find that after assembling them the system is always very hard. I see in the assembly YouTube videos that everyone finds it fluid but I have to use a lot of force to move the head. I checked the x...
Top