Recent content by DanPin

I have had prints run fine over more than 24hrs. Today I had a filament motion pause and was looking at my settings. Two things I don't understand. #1 #event_delay: 3.0# The minimum amount of time in seconds to delay between events.# Events triggered during this time period will be...

Thanks...I am always learning new bits everytime I post a question....or just read the forum in general

Thanks for the g-code examples, I will give them try. It seems like "Tip Ramming" and "Short retract with a dley" accomplish the same thing. Looking forward to less (or none) clog issues.

On my stealthburner with Phaetus Rapid0 2 I normally just heat the extruder to 220 and reverse the motor until I can pull out the filament. On occasion, I am letting some plastic melt in the heat break and then can't get the new filament through the heat break. My method for clearing this is...

Thanks Dave for all of that info. If I run into any more issues with the Phaetus, I will surely give the REVO a try. Wish I knew more about hotends when I ordered my Formbot kit.

Hold on there....if you think I should switch to the REVO, you need to give me the reasons:p I did a quick read and like the ability for nozzle change when cold. What are the other benefits? Does it use the same toolhead mount as the Phaetus? Is the heat break really part of the nozzle???

I looked at this closer. Found that the nozzle was loose. I believe filament leaked out of the nozzle threads, and because of the tight silicone sock, it creeped up to the thermocouple. Trying again with a tight nozzle. Wish I Could have deleted my orig post.

I printed some long 14hr prints with red PLA. Now I have some blue filament, and noticed some "blobs" of red filament getting deposited. I took off the silicone nozzle sock and found a large blob of red plastic around the thermocouple threads and the heater block. I have not gone any deeper...

These artifacts have shown up each time I have printed this part (Voron Handle). They only show up on one side of the part. Using Matterhackers Nylon filament. I have not dried it, but I am in AZ. These artifacts seem to show up in about the same place on both parts (I print the one at a...

Excellent...Thanks ....

I am trying to sort out my printer.cfg file since I added a EBB 2209 toolhead board. I am including the BTT 2240 config file, but I am getting shutdown errors because I "think" I have some things double defined. Is there a was to block out a section of the config file? I currently have a...

Got the basics working....went with a BTT U2C adapter for overall simplicity...thanks for all the help...it was a good education.

OK, I understand what you are saying,,,,but it really seems strange. Based on your post, if the Octopus is in "CAN-Bridge" mode, and my EBB is connected to Octopus as a CAN device, everything coming over the USB-C from the Pi will be using a CAN_UUID for BOTH the Octopus and the EBB. I will...

With what several very kind forum members (including shiftingtech) have explained, I believe I need to do the following.: For flashing Klipper to each MCU, I need to specify the comm's method for "that particular MCU" in menuconfig So Octopus is serial and EBB tool head is CAN-bus. Then in the...

Thank You So much. The two of you have shown me the way. If this info was in any of the videos I watched, I sure did miss it. But now this all makes sense. Thanks Again....issue closed✅✅✅...had to find the right emoji.... Oh...wait, one more missing piece that I need you to confirm. When I...