What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by HoloPuff

  1. H

    Bad calibration cubes and running out of ideas

    My cubes are really bad and I don't know what to do anymore. Printer: V2.4 LDO 350mm with Revo 0.4mm nozzle, StealthBurner, Tap Max acceleration set to 3000 Extruder rotation_distance has been calibrated and verified Material: ABS (AMZ3D) gray Left Cube: nozzle=240c, extrusion...
  2. H

    Help with filament runout sensor not triggering

    Hey gang. I have an LDO 2.4 kit with Octopus board and Klipper. I hooked up a filament runout sensors to Pin PG11 This is the config I'm using: https://github.com/VoronDesign/VoronUsers/blob/master/printer_mods/JD/RefillPlease/klipper/filament_runout_detection.cfg (I just changed the pin)...
  3. H

    Parts detaching, most prints fail. What am I doing wrong?

    I'm having a really hard time with parts detaching and prints failing. This is a new V2.4 LDO kit, printing ABS, bed at 110c. Good first layer squish. Bed was cleaned with soap and water and left to dry, untouched after. What am I missing here?
See more
Top