What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by IBCrazy

  1. I

    Question Voron 2.4 Fysetc bearing problem

    In a pinch, drop your bearings in some 20W50 motor oil and heat it up until it is hot to the touch. Then let it cool down and remove the bearings. The heat thins out the oil and lets it move past the seals. The cool down thickens it up so it stays in when you remove them from the oil bath.
  2. I

    Help，I came across strange patterns

    What did you make your carriage assemblies from? It is possible that you have flexing in them causing them to not center perfectly. If you used PLA, they might be softening up in the heat of the enclosure.
  3. I

    What is the max safe bed temp for stock V2.4r2?

    If the adhesive is not high enough temperature on the magnet bed, you can pull the magnet up and clean it off with a solvent like Xylene. This will remove the adhesive and give you a fresh starting surface. Then to adhere the magnet base you can use a different contact adhesive to adhere it...
  4. I

    Question Voron 2.4 Runout sensor code not pausing print

    I am having issues getting my runout sensor to be recognized by my Voron 2.4. I am running the Octopus control board and I have the sensor plugged into "PG12" (the connector below my Z-position sensor). I tried the code on this website and it didn't work, so I tried the "refill please" code...
  5. I

    Question Proper (safest) way to shut down/shut off the Voron 2.4

    So I finally got my Voron working after several issues. However, when trying to turn off the machine from the interface (using the power icon and selecting "shut down" , it will disconnect and not reconnect, but the stepper drivers are still on and the fans are still running even after several...
  6. I

    De racking, again.

    I had this exact same problem with mine. I didn't go and re-measure the belts, though. What I did was move the gantry all of the way forward and zip tied it tight to the front on both sides. I then loosened the tensioners in the front all of the way, then removed the extruder so I could...
  7. I

    Question Gantry moves diagonally and rough in -X and -Y directions, but properly on +X and +Y directions

    That was it! Missed the bearing in the front left side!. Thank you!
  8. I

    Question Gantry moves diagonally and rough in -X and -Y directions, but properly on +X and +Y directions

    This is driving me nuts! Voron 2.4. Machine homes properly. Smooth in X, Y, and Z. However: When telling it to move in -Y (-100) it runs rough and moves diagonally -50Y and +50X. When telling it to move in -X (-100) it runs rough and moves +50Y and -50X Yet: when telling it to move +Y...
  9. I

    MOTOR A B wrong direction

    I had the same problem with direction being reversed on all of my Z stppers. Change the line: dir_pin: PF12 to: dir_pin: !PF12 The exclamtion point is the "not" command which reverses direction in a stepper drive. I hope this helps.
See more
Top