What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by jdm3d

  1. J

    Question AB Belt rubbing and alignment

    I re-racked it and still saw the issue. Moving the print head around, there seemed to be some binding with one of the X/Y motors. I couldn't tell which one and thought it better to swap both to have a matched set. I swapped out the X and Y motors (for LDOs) and no longer see the issue. Side...
  2. J

    Question AB Belt rubbing and alignment

    My 2.4 350mm build is mostly working, but after a few dozen prints I'm starting to see layer shifts. After a moderate amount of Googling, the most popular answer was "Look at your belts". I took the panels off and I am seeing some "belt dust" and I see at least one of the belts are not sitting...
  3. J

    Fysetc 2.4 kit 625 bearing size problem

    Building a new Voron 2.4 from the Fysetc kit and need some advice. I'm on pg 33 of the manual, tying to put the 5x60 shaft through the 625 bearings. There is a tolerance issue and the rod won't fit inside. The provided bearings show 4.94mm ID and the rods are 5.15mm. The rods fit in the...
See more
Top