Recent content by JendaDH

Hi, yes it was (and still is). Experience beforehand, well I have some background like I know how to crimp wire, I have been RC model fan / builder for some time, so that probably helped with the mechanical / electrical side of things with the build. On the other hand, the 2.4 has such a good...

Interesting, will look into that too. I have my infill at 30% for solid. Will look at the perimeter, might be better option to get nice corners without bulging.

Just for the record here, I managed to resolve the gap in perimeter by tuning PA and smooth timing.

Good luck with your repair. Reach out if you run into troubles with print. I am total newbie, so I am sure you'll do just fine ;-)

I have the same issue I'd say. Fresh built v2.4. I have clear gap in perimeters when there is sharp turn. I tried to play with PA from 0.038 to 0.052. The later is what the Ellis guide points me to. My nozzle is 0.4, extrusion width is also 0.4 here are the details: My EM is around 93% to...

So the whole "in-layer" material change started when I printed solo the MiniSB head for Micron and the logo. Even when I sanded both parts, the fit was not good enough. Most problematic was the MiniSB cowling with those "bridges". The logo is I think two layers thick only, maybe three, not more...

I’ll share in couple of hours, just in transit somewhere now

Hi, I believe the MIC6 describes the material - heat soked / reliefed aluminium. This means the bed should warp less then just casted and machined aluminum material, that would still have some internal stress.

Hi, I went through this yesterday when I started to print parts for Micron+. I wanted to have the Micron logo embedded to the MiniSB cowling, so changing filament on layer level did not work for me. What I ended up doing is defining in slicer (PS) that I have two extruders and use the multi-part...

Hi Mike, I got it off Aliexpress. Here is the link to the item I bought -> https://www.aliexpress.us/item/3256804007759638.html?gatewayAdapt=glo2usa4itemAdapt&_randl_shipto=US You should see review from me for this item to ensure you're looking at the same thing.

It is unbeliveable how much dust the acrilic panels attract ;-) I managed tu put most of the skirt on. I printed the parts from the Voron github repository, but the central rear part is too big. I will print the rear right (view from front) with the key stone slots from the repo as well as it...

So I finaly managed to find some time in between print queue to update the SB with the TAP. I must say it was fun to assemble and really enjoyable. It is amazing how parts are designed and how components fall into place. Where I had to take some time was putting the GT2 belts through the accent...

Not much of an activity lately. Started to print bits and pieces for the printer, like the LED strip clips for the interior lightning, skirt parts, back panel plate. I am preparing to migrate SB toolhead to TAP. Parts are printed, HW is also ready, so probably an activity for weekend along with...

Got the neopixel LED's working today. I have soldered string of three on bench, hooked them up to Octopus Pro and boom, all worked instantly. I took the LED chain out of the SB toolhead and replaced with the one I tested on bench. Now I have working neopixels in the toolhead 👍 I will check the...

Hi, so I have replaced the faulty PT1000 sensor and as precaution I replaced also the 4010 hotend fan. Everything started to work nicely, managed to tune the 1st layer squeeze, started to print some samples so I could see how things work. What I am struggling with now are the neopixels in the...