Recent content by kar883

Nope. After a few months of failing to fix the issue with Tap I switched back to the inductive sensor and the printer has been working fine.

I circumvented the toolhead PCB by wiring the 24v, ground and signal wires directly to the optotap pcb and I get power the optotap sensor PCB to power on and I can correctly get the red and blue lights when there is something blocking the optotap sensor beam however in mainsail I could not get...

Probably another noob issue but I need help. I've had everything running fine without issue until one day (about 6 months ago) the hot end crashed into my bed breaking the TAP mount. Since then I've gotten the TAP mount reprinted and everything is as it was except my optical sensor seems to not...

Probably another noob issue but I need help. I've had everything running fine without issue until one day (about 6 months ago) the hot end crashed into my bed breaking the TAP mount. Since then I've gotten the TAP mount reprinted and everything is as it was except my optical sensor seems to not...

Alright, I'm a total noob 😤.... I had the probe pin plugged into the wrong port. I was using the ~!PB7 in the config file but had it plugged into the PG15 slot on the board. Thanks for your time and patience with me. All is working now!

@NoGuru Printer config attached. This is what my Z endstop/probe look like regardless of Tap position. I refreshed the endstops while lifting and then again when lower Tap/toolhead. While up I see the red led light from the optical sensor on Tap indicating Tap properly powered and it turns off...

I'm running stealthburner with CW2 on my 2.4 and have tap installed using an OptoTap PCB OPB sensor and Hartk1213 5-24v stealthburner pcb. My Z endstop/probe for Tap are always triggered in klipper and I do not understand why. From reading the Tap manual I shouldn't need the 220 ohm resister or...