Recent content by LasseKongo

Thanks for the replies. I guess I will start with the 6000 rpm GDStime and see how it performs, after all it is pretty easy to replace if needed.

Finally getting to my long overdue replacement of the Afterburner with a Stealthburner on my 2.4. I have purchased a couple of 5015 fans for part cooling, GDStime 4500 rpm sleeve bearing and 6000 rpm ball bearing variants. Connected them to a bench PSU for testing, and the difference in noise...

Thanks for sharing. I might go for three and just adjust the PWM power if it gets to bright.

So far I have only powered them from a bench power supply to verify that they work. Since they consume 0.1A each @24V I think it will be safe to connect two of them to a fan output and use PWM to reduce the intensity if needed.

I have just got the PCBs and components to make a couple of Daylight on a stick LEDs. For those of you that use this or similar, how many did you put in the printer ? And at what positions ? I will be able to make five of them, so theoretically I could put four of them in the top, but maybe that...

Thanks, Maybe I will try tapping 24V of the hotend terminal, it is pretty easy to put two wires into the screw terminal.

Just ordered an EBB42 CAN board from Aliexpress, of course without fully reading the docs first... According to the picture below the probe pins only supply 5V, and not the 10-30V the standard probes seem to use. I assume this rules out the connection of the standard typ probes to this board. I...

Thank you, thank you, thank you! A real forum with threads is so much better than Discord.

I bought a Formbot 2.4r1 kit that I built as a 2.4r2. In general I was very happy with the kit. Stuff I changed during the build: * Noctua skirt fans, the included Sunon fans were LOUD * Titanium backers * Aluminum composite panels from Fermio * Mechanical X/Y endstops instead of hall-effect. *...