Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
I encountered an issue while printing the "Filament_Card_Caddy" model. There is a depression appearing on the side where the VORON logo is printed. I checked the slicing and printing paths and noticed that the depression occurs at the starting and ending points of the last outer wall. I wonder...
Thank you so much for your reply! I doubled checked the file that it was the latest, and I printed a test cube to check the accuracy but didn't find problems. I tried to adjust some factors, like PA, but didn't change much. I added a little bit of the "outer XY size of compensation" which do...
Thank you so much for your reply! I doubled checked the file that it was the latest, and I'm not scaling the parts while printing. I tried to adjust some factors, like PA, but didn't change much. I added a little bit of the "outer XY size of compensation" which do help, -0.03 was my setting. I'm...
Hi guys I have a problem that confuses me. I have adjusted my printer(VORON 2.4), PA, EM, hole enlargement etc. all done, but when printing Stealthburner Clockwork2 guidler a and b, these two parts are quite difficult to assemble, it seems the discrepancy was quite large. Does anyone have any...
My heat bed temperature sometimes suddenly stops and cools down during the heating process, yet the power I see is at 100% and the SSR is also operating (the operating red light is on). If left alone, it eventually reports an error, but if I manually set the target temperature to 0, then back to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.