Recent content by Locky83

Thank you. We got it working!

I did read that yes, but it is written for someone who knows what all that means, which I do not. For someone like me, unfortunately it's not enough to get me going. I think I need to do this: "if you can't find it in the web interface, use sftp to grab the log (for example Filezilla, WinSCP)...

Hi All, I've got a BTT TFT43 screen on my 2.4 and this morning I installed Klipperscreen using Kaiuh Everything seemed to go to plan, but my screen just still shows all the pi stuff like it did before. I have tried following the troubleshooting but there are also no klipperscreen log files...

I figured them both out! I just had to walk away from it and come back a day later to see the forest through the trees. Z1 Stepper was not working as I had Enable Pin commented out. I changed the thermistor from Generic 3950 to PT1000 and that solved that problem.

Thanks again for that help, just got back from a family Summer holiday so I'm back at it now. I have been struggling all day trying to figure out 2 issues before asking for more help but it's time to give up. When I "STEPPER_BUZZ STEPPER=stepper_z1" This stepper motor is not responding, all...

wow that fixed it, I would have never worked that out on my own as the error never pointed me there. thank you so much!

Hi All, Complete Noob here just trying to help my son get his Voron 2.4 350mm build up and running. I am following this video by Scott Corn In addition to this, I am following this video by Nero 3D for the changes to suit TAP: I've made all the relevant changes in both of these videos and I...

Thank you so much!

Thanks, so just like the Voron manual shows? Because the Octopus Pro shows PB7 somewhere else, and the area I think is PB7 says nothing at all - which is what led me to the confusion. While I have you, I have another question. I have a Dragon hot end, the temperature sensor and heater have 2...

Thanks so much for your reply! PIctures attached of the Octopus Pro and the TAP, it was a bit awkward to get to to get a good picture of it. Here is a link to the TAP from where I bought it from: https://uniqueprints.shop/shop/electronics-electrical/pcb/voron-tap-pcb-optotap/ Thanks in advance!

Hi all. I’m helping my young son build a voron 2.4 with stealthburner and when it got over his head he asked me for help and now I’m well in over my head too. I’m no expert in anything at all to do with this, I’m just a machinist. I’ve spent days trying to find just 1 piece of information to...