Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Ok I figured out where the 230x230 position was coming from. I have a file called kiauh_macros which has a pause print macro in there and it was set to park at 230 x 230. I changed that to 5 x 5 and now it pauses where I tell it in prusa slicer and starts again when I hit the resume button.
So...
Are you talking about this drop down?
I tried setting x and y to 5 there but I still got move out of range 230.000 230.000. Is there somewhere in the slicer I need to set the parking location?
Trying to get M600 to work. I am copying the macro from the klipper github which is:
# M600: Filament Change. This macro will pause the printer, move the
# tool to the change position, and retract the filament 50mm. Adjust
# the retraction settings for your own extruder. After filament has
#...
I got this housing https://www.digikey.com/en/products/detail/molex/0436400201/268984
and this pin https://www.digikey.com/en/products/detail/molex/0430315003/7802154
Did I get the wrong pins? I can't seem to get them to go into the housing far enough to click in.
I ordered these on digikey https://www.digikey.com/en/products/detail/molex/0436400201/268984?s=N4IgTCBcDaIAwBYDMA2Bc5jgRkHAEIBdAXyA hopefully I got the right one this time. I would rather keep the factory connectors on the revo if I can.
Anyone know what the two pin connectors that come on the revo heater and thermistor are called? I did pay close enough attention and ordered these https://www.amazon.com/dp/B078Q5CC3P?psc=1&ref=ppx_yo2ov_dt_b_product_details which have the latch on the wrong side. Are they still a molex microfit...
Are the little spots in the first photo maybe the start or end of a layer? I have always had abs nozzle temp higher than 230. The stuff I have now I am using 255. For warping what is the bed surface?
Anyone found something for the formbot 2.4 kit that explains which harness is for what exactly? I am uncertain which on they expect you to use for the part cooling fan and the hot end cooling fan. I am thinking the ones labeled fan0 and fan1 but they also have one labeled fan2 which doesn't seem...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.