Anyone know what the connectors that come on the revo are called?

[msaeger]

Anyone know what the two pin connectors that come on the revo heater and thermistor are called? I did pay close enough attention and ordered these https://www.amazon.com/dp/B078Q5CC3P?psc=1&ref=ppx_yo2ov_dt_b_product_details which have the latch on the wrong side. Are they still a molex microfit 3 or are they something else?

 

[msaeger]

Anyone know what the two pin connectors that come on the revo heater and thermistor are called? I did pay close enough attention and ordered these https://www.amazon.com/dp/B078Q5CC3P?psc=1&ref=ppx_yo2ov_dt_b_product_details which have the latch on the wrong side. Are they still a molex microfit 3 or are they something else?

Also I am looking for a extraction tool for the microfit 3 connectors.

 

[msaeger]

I ordered these on digikey https://www.digikey.com/en/products...268984?s=N4IgTCBcDaIAwBYDMA2Bc5jgRkHAEIBdAXyA hopefully I got the right one this time. I would rather keep the factory connectors on the revo if I can.

 

[Dave]

The original ones were indeed microfit 3.0 connectors. The last link that you has were indeed the mating connectors. As for extraction tools, well, um, they are all pretty terrible. The only ines I’ve heard of that work well are the Molex ones. I, personally, haven’t had good luck with any of them, but that’s the best success story I’ve seen.

 

[msaeger]

The original ones were indeed microfit 3.0 connectors. The last link that you has were indeed the mating connectors. As for extraction tools, well, um, they are all pretty terrible. The only ines I’ve heard of that work well are the Molex ones. I, personally, haven’t had good luck with any of them, but that’s the best success story I’ve seen.

Thanks for confirming I got the right ones!

 

[claudermilk]

Yes, they are MicroFit 3.0. For extraction a trick I read about that works is to use a cell phone sim ejector tool. I stole an extra one and it's now in my toolbox. $0 and works sure beats $25-$60!

 

[msaeger]

Good idea about the sim tool I have several of those. I am going to try it when I get home!

 

[msaeger]

I got this housing https://www.digikey.com/en/products/detail/molex/0436400201/268984

and this pin https://www.digikey.com/en/products/detail/molex/0430315003/7802154

Did I get the wrong pins? I can't seem to get them to go into the housing far enough to click in.

 

[msaeger]

Looking at the data sheet Molex says it needs 43031 digikey says I got 0430315003 . They seem too tall to fit in the housing.