Recent content by NegativeFate

save creating a new thread im just tapping onto my old one since last post ive recrimped and was overly anal about getting them right, noticed krakens pins for a1a2b1b2 were different so swapped them over tried a whole range of run current every change to config ive been able to get my hands...

hey mate, been flat out... yeah i still cant get it going hey new motors even arrived so ive thrown them in... literally everything is now brand new and the problem persists has to be config then... i just cant see it

Hey thanks mate, yeah I thought run current at one point but I’ve tried up to 1.7, I’m thinking maybe there’s something up with the motors themselves maybe, I’ll suss out your config when I get home and see what I can come up with, cheers

me again, getting same issue with a different board, running a kraken while i try and figure this out and same thing happening pretty sure its not the wiring because i had to recrimp for the kraken and tested the ends for continuity so im sort of stumped hope someone can help

Could have sworn I attached the klippy log, not home atm but I’ll put it up when I get back, octopus pro 723 Everything’s pointing to wiring but I’ve gone over and over it and recrimped a couple times now to be sure

hey all, after a long break from the printer thanks to the kids spilling something and frying everything.... ive finally gotten around to putting together essentially a whole new printer... new psu's, board, drivers and pi got some of the btt tmc5160 pro drivers and i get this message come up...

All sorted mate, was a problem with the print_start macro As far as I’m aware.. [fan] can’t be changed? I stand to be corrected tho

Hey all, put the g2e in last night and when I was finished I went to start some calibrations.. but during the print_start I get this message “the value ‘Fan’ is not valid for FAN” Had a look in the klippy log and it doesn’t really tell me much (that I can see anyway) hoping someone has any ideas?