VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
NoGuru's latest activity
-
NoGuru replied to the thread Question Newbie first layer issue.I would go through this tuning guide. https://ellis3dp.com/Print-Tuning-Guide/ Make sure you filament is not getting stuck in the path... -
NoGuru replied to the thread Traded my Raspberry Pi 4 for a Rpi 5.It's close to the same. I have the TFT50, but it's the same. I think I am just going to delete the screen for now. I know BTT has the...
-
NoGuru replied to the thread Traded my Raspberry Pi 4 for a Rpi 5.One thing I lost and I have not looked into much is my Klipperscreen. I use one of the BTT screens with a ribbon cable and PI5 has mini...
-
Life always gets in the way of hobbies and pleasures. I hope things sorted themselves out by now and you can get back to doing zero...
-
NoGuru replied to the thread alie express????.Yeah, I think they will do just fine for a base setup. I took my V0 apart a while back, then some life events happened and it has been...
-
I know its not a needed upgrade but I think it was worth it. It was pretty easy to just move my config over and reinstall packages...
-
NoGuru replied to the thread alie express????.The link tells me the page cannot be found. I don't know if I would go with a "budget kit" if that was what the link was. I recommend...
-
NoGuru replied to the thread Poor Quality Print on Corners and sharp shapes.I cannot stress enough that you should go through every aspect of this tuning guide. If the printer is sound, it will dial you in...
-
Yes doing upgrades should be done gradually since it can end up like building a whole new printer in one go. But for me this time it...
-
NoGuru reacted to Mike4D's post in the thread What features would you like to see in 0.3? with
Love.
V0.3 you say? What new features, you ask? Ask no more, I got this :D Just add two more Z Steppers and MGN7 rails, no extra chances... -
Yep! I strive for that too and definitely recommend it, although there are rare exceptions such as is when things are tightly correlated...
-
NoGuru replied to the thread Upping my umbilical game.I can tell you have tried almost all Z probes except Cartograher and the Piezo one...one on a Voron. Well Beacon is by far my favorite...
-
NoGuru replied to the thread Upping my umbilical game.Back when XOL was in its first stages, the guys did a group order from PCBway or some other site that can do SLS...or was is SLA...I...
-
NoGuru replied to the thread Chamber temp for tall, single-wall ASA.Yeah I understand that. I would say insultation will help, but it may or may not fix it. Turbulent air is bad, but if you keep the fans...
-
NoGuru replied to the thread Chamber temp for tall, single-wall ASA.You can help chamber temps by creating a convection oven by adding some bed fans. They help circulate the hot air and improve chamber...
