VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by paulbarton

  1. P

    QGL issues post upgrade

    SOLVED: checking everything carefully again I found one joint on the frame loose, a couple of slightly loose screws on the X gantry, all 4 Z drive belts belts from the motors to have way too much slack. Redid the Probe_ACCURACY samples=100 and got SD of 0.0024. I was then able to do QGL followed...
  2. P

    QGL issues post upgrade

    Thank you. I've checked gantry bolts and all tight. I'm puzzled why the toolhead just stops on the tolerance error and then sits there until you home. When it homes X it drops off the side of the bed and then pops back once X has homed. Doesn't seem right.
  3. P

    QGL issues post upgrade

    Hi it was working really well prior to Z height upgrade. I assume you increase the tolerances in the printer config file
  4. P

    QGL issues post upgrade

    I'm having a bit of trouble with my Voron 2.4r2 with TAP. I just extended Z height and now can't get QGL to work. It starts ok but at some point it comes up with the out of tolerance error and just stops with the nozzle in contact with the bed. Home all and it traverses the bed homing X and then...
  5. P

    V2.4r2 - bed position post TAP install

    Thank you - I'll have a look later today when the printer stops (which is rare) Paul
  6. P

    V2.4r2 - bed position post TAP install

    yes - [probe] ## Inductive Probe ## This probe is not used for Z height, only Quad Gantry Leveling ## Select the probe port by type: ## For the PROBE port. Will not work with Diode. May need pull-up resistor from signal to 24V. #pin: ~!PB7 ## For the DIAG_7 port. NEEDS BAT85 DIODE! Change to...
  7. P

    V2.4r2 - bed position post TAP install

    Hi I have upgraded from CW1 with Omron probe to Stealthburner with TAP. When I QGL the probes points are displaced towards the front by around 40mm and the print is also dispaced by the same amount. I'm pretty sure its because the old probe was about the same distance from the nozzzle. Now I'm...
  8. P

    LGX Mount for TAP

    Can you share the STL please.
  9. P

    LGX Mount for TAP

    can you provide the STL file please?
Top