Recent content by Pigeon

They are going on a V2.4 300mm

info on linking two of them together, as assume most people have two of them. So, parallel vs series, wire routing and so forth.

The Git seems a little lacking when it comes to actually wiring them. https://github.com/VoronDesign/Voron-Hardware/tree/master/Daylight/Disco_on_a_stick

RPi 3 will be fine. Or there are some cheap alternatives out there too.

Let try that again...

OK, really hitting a brick wall here with my Y-axis input shaper, stripped all my panels off, loosed my belts and then went round and checked all my bearings were spinning freely, look really hard for any tell tell dust or ware on the belt with no joy, loosened the gantry and made sure it was...

No, totally just a cheap generic 60c rated PE or PVC it's very much going to get replaced when I rebuild with SB and TAP. Got sent the kit to make an unboxing video in English and they want a finished build video too, so I kind of need to stick with stock parts that it came with and only...

I guess that brings me to a second point, my chain doesn't actually have any anchors for zip ties (always been under the impression you really want them fixed at each end of the chain) and putting cable ties inside the cable chain itself seems like a snag waiting to happen. So...given the...

Hello, just after some advice on my loom. It is a PTFE-coated loom with the exception of the 4 wires for the X-Y endstop, and my first instinct was to put cables in the chain without the included sleeving, just feels a little like asking for trouble having a mesh nylon sleeve packed in the...

For those using Deck Panel Support Clips....How many are on each side of the bottom are you using?